EuroPatch Fine

Description

EuroPatch Fine is a specially manufactured water based Acrylic low shrink stopping compound for filling FC sheet joints, as well as patching areas to be painted since EuroPatch Fine can be sanded down to a smooth finish. It gives a finish with strength and flexibility.

Preperation & Application

Prior to the application of EuroPatch Fine make certain the substrate (particularly over FC sheeting) has been fitted by the Builder according to the manufacturers instructions, especially fixing correct batten placement, correct positioning of expansion joints etc.
Make certain the substrate receiving EuroPatch Fine is clean and free of any dirt, grease, fungus, dust, mould releasing agents, etc.
When applying EuroPatch Fine use a trowel or spatula to fill the rebated joints pressing firmly to ensure good adhesion, then trowel into the EuroPatch Fine a 50/60mm strip of alkali resistant fibre glass mesh, then trowel on another thin coat of EuroPatch Fine to fully encase the mesh and leave a smooth surface. Make sure care is taken to “feather” the edges along the entire application. A second layer of tape may be applied in areas prone to movement or where anticipated problems may occur.

Coverage

Coverage rates will vary depending on the substrate and the thickness applied, but as an approximate guide 15 Litres of EuroPatch Fine should cover and stop approximately 60 linear metres of FC sheet joints.

Wash Up

Euro Patch Fine is water based Acrylic material, and as such tools can be washed in clean water. They should be washed before the material dries.


First Aid

  • If swallowed do not induce vomiting. Give plenty of water to drink. Contact a doctor or the Poisons Information Centre.
  • If in eyes hold eyes open and flood with clean water for at least 15 minutes. See a doctor if any irritation occurs.
  • Materials Safety Data sheet available on request

Indemnity

Euroset Trading Pty Ltd & Euroset Manufacturing Pty Ltd will not accept responsibility for any misuse of this product or if not applied by an approved Euroset applicator and in accordance with our technical specifications.
Due to our policy of continuing product improvement Euroset Manufacturing Pty Ltd reserves the right to change these specifications without further notice.

home