EuroPrimer

Description

EuroPrimer is formulated with pure acrylic resins designed to permeate and seal the substrate including masonry surfaces, brick, sand and cement renders, AAC walls (Hebel), FC Sheeting etc

Preparation

Ensure the receiving substrate is dry and free of any dirt, grease, dust, fungus, flaking paint, mould, releasing agents etc. Make sure the receiving substrate is smooth and straight enough to receive the finishing coat that will be applied over EuroPrimer.

Application

Stir contents thoroughly prior to use. EuroPrimer can be brushed, rolled or sprayed onto the primed substrate. To achieve a high quality finish a “wet edge” must be kept during application.

Caution

• Provide adequate ventilation during use
• Do not apply when temperature is below 10°C or when drying time is below 10°C.
• Avoid exposure to steam and condensation for 48 hours after application of final coat.

First Aid

If swallowed, Do Not induce vomiting. Give plenty of water to drink. Contact a doctor or the Poisons Information Centre. If in eyes, hold eyes open, flood with water for at least 15 minutes, and see a doctor if any irritation occurs. Material Safety Data Sheet available on request.

Indemnity

Euroset Trading Pty Ltd & Euroset Manufacturing Pty Ltd will not accept responsibility for any misuse of this product or if not applied by an approved Euroset applicator and in accordance with our technical specifications.Due to our policy of continuing product improvement Euroset Manufacturing Pty Ltd reserves the right to change these specifications without further notice.