EuroTexture

Description

EuroTextures are high quality acrylic texture coatings, able to be applied by trowel or air spray, and may be used internally or externally.
EuroTextures are manufactured from the highest quality emulsions, sands and selected fillers, together with fungicides to provide a long lasting high quality finish.
EuroTextures can be used over many surfaces including EuroRender and EuroSkim, conventional cement render, FC Sheets, Pre cast panels, etc.

Application

The renderer shall check that the colour is correct prior to use. Substrates suck a traditional cement render, FC sheet, AAC walls, pre cast concrete etc. must first be coated with EuroPrime.
The desired EuroTexture coat is then troweled on to the substrate to a thickness determined by the coarsest particles and the coating is floated with the appropriate float or trowel (see below in product range). Be sure to maintain a “wet edge” to minimise the chances of a line appearing in the finished façade. On larger walls try to incorporate a disc cut between floors and /or different substrates to minimise problems. Ensure sufficient trowel hands are available on these large areas.
Avoid applying EuroTexture in windy conditions or temperatures outside 16°C – 26°C. Keep newly coated areas protected from rain and moisture for at least 2 hours, longer in the lower temperature range.

Product Range & Coverage

EuroSand Stone Our medium sand style that is troweled on with a steel trowel and finished with a red plastic float

SandFinish Our coarser sand style that is troweled on with a steel trowel and finished with a red plastic float

Euro1mm A fine scratch coat that is troweled on and usually finished with a wooden or polystyrene float in a circular fashion

Euro2 & 3mm Our heavier scratch coat that is troweled on and usually finished with a wooden or polystyrene float in a vertical fashion Safety.

EuroRustic Our low sheen Acrylic Paint with sand in suspension for roll-on application

EuroFine Coat Our fine sand style that is troweled-on with a steel trowel and finished with a red plastic float

First Aid

• If swallowed do not induce vomiting. Give plenty of water to drink. Contact a doctor or the Poisons Information Centre.
• If in eyes hold eyes open and flood with clean water for at least 15 minutes. See a doctor if any irritation occurs.
• Materials Safety Data sheet available on request

Indemnity

Euroset Trading Pty Ltd & Euroset Manufacturing Pty Ltd will not accept responsibility for any misuse of this product or if not applied by an approved Euroset applicator and in accordance with our technical specifications.
Due to our policy of continuing product improvement Euroset Manufacturing Pty Ltd reserves the right to change these specifications without further notice.