EuroProyalbi & Fino Plus
One Coat White Set

Proyalbi is a pre packed, quality controlled fine powdered off white render, that mixed with water can be applied by projection machinery or by hand, directly onto brick, AAC and concrete walls etc.
It has the unique ability of being able to be applied at various thicknesses from 1 to 100mm in one coating, and yet will notdisplay the usual sand and cement weaknesses such as cracking, “herringboning” and drumminess. It can be applied and finished at a much faster rate than traditional render and set applications.
Due to the nature of building sites, set walls are often damaged by other trades. This is a major problem with traditional set finishes but not with Proyalbi and Fino Plus, as a quick skim of Fino Plus over damaged areas leaves the surface ready for painting saving time and money.

The Builder and Applicator must make certain that the receiving surface area, (be it clay or cement bricks or blocks, AAC Blocks or panels, poured concrete walls or ceilings etc.) are clean and free of adhesive inhibiting materials such as dust, grease, dirt, fungus, mould releasing agents, excessive water etc.
Surface areas such as FC Sheet, Polystyrene etc. must first be coated with EuroRender and alkali resistant Fibre Glass Mesh prior to Proyalbi being applied. Expansion and differential surface joints must be expressed. Should you wish, please contact our head office for consultations concerning Proyalbi and Fino Plus applications.

When applying by machine, water is supplied to the machine and it automatically mixes and sprays the product onto the wall.
When mixing by hand, Proyalbi and Fino Plus can be prepared in a bucket by drill, in a conventional cement mixer or by trowel on a table. In all cases pure clean water must be used.

• Having made certain the surface is clean the product can be troweled or sprayed on to the thickness required, and immediately ruled off with an English Feather straight edge to provide a flat surface.
  The face is then left until it is starting to firm to the touch, whereupon it is sponged either by a hand sponge or with a variable speed electric sponge. If the face has firmed up to much, it can be misted with water to “bring it back”.
  The surface is then worked with a steel trowel to bring it to a smooth state.
  A final coat of Fino Plus is then applied when the Proyalbi coating has firmed up before it goes fully dry. This Fino Plus application is mixed to a very liquid consistency and applied by steel trowel as a thin watery coat to give a high quality finish.
  This same Fino Plus mixture is used to repair any damage to walls caused prior to painting as mentioned in the 'Description'.
  
• Fino Plus can be applied over sand and cement render that is straight and true. Two or three coats will be needed to achieve a high quality finish that is harder and stronger than traditional set finishes, with no otherworries creating the mix.

Proyalbi and Fino Plus surfaces must be primed with an oil based sealer. Subsequent coatings can then be as the owner requires.

The coverage is wholly determined by the thickness required on the wall.

All tools or machinery are cleaned in water      


Press play to view preview.